Error code · Washer

Kenmore 417 Front-Load Washer Code E11: Water Takes Too Long to Fill

Medium · inspection needed

Code: E11
Appliance: Washer
Brand: Kenmore
Warranty: 30-day workmanship

What E11 means

On Kenmore front-load washers whose model numbers start with 417, a Frigidaire and Electrolux-built platform, E11 means the fill time ran too long, so the tub did not reach its water level in the expected time. The cycle stops. This applies to the full model 417.44130000 and to digital-display versions from 2014 onward. You may see the drum nearly empty, hear no water running, or find the cycle sitting idle at the start.

Common causes of E11

Water supply faucets not fully open
Frozen or kinked fill lines
Fill hoses or inlet screens restricting flow
Water inlet valve

✓ One safe check you can try

1. Make sure both water faucets behind the washer are fully open. 2. In winter, check whether the fill lines may be frozen. 3. Look for kinks in the fill hoses. 4. If water flow still seems weak, call us before taking the hoses off.

! Why to stop there

Whether the house supply or the washer is restricting flow
Poor flow may need a plumber to fix the house side
We test flow through the fill hoses before suggesting the inlet valve

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

SFKenmore 402 Front-Load Washer Code SF: Control board error SLKenmore Calypso Top-Load Washer Code SL: Excessive suds Spin LED onKenmore 110 VMW Top-Load Washer Spin Light On: Drain took too long Sud / SUDSKenmore Washer Codes Sud and SUDS: Excessive suds on 110, 796 and 402 front-loads tEKenmore 796 Washer Code tE: Thermistor and heating UEKenmore 796 Washer Code UE: Unbalanced load uLKenmore 110 Oasis Top-Load Washer Code uL: Unbalanced load Wash LED onKenmore 110 VMW Top-Load Washer Wash Light On: No fill or slow fill

E11E11 questions

What does too long a fill mean?

The washer waits a set time for the tub to fill. If the water level is not reached in that time, E11 appears and the cycle stops, usually because water is not arriving quickly enough.

Could my house plumbing be the cause?

Yes. Low water pressure or a partly closed valve behind the washer is a common reason. A plumber may be needed if the house supply is the restriction, and we tell you if that is the case.

Is this the same on digital models?

Yes, the digital-display 2014 and newer version uses E11 for the same fill-time condition, so the same checks apply. The difference is only the panel, not the fill path.

Book a visit

Still seeing E11?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 955-7152