Error code · Washer

Kenmore 110 Front-Load Washer Code F27: Too much water sensed

High · stop use, call now

Code: F27
Appliance: Washer
Brand: Kenmore
Warranty: 30-day workmanship

What F27 means

Kenmore washers with model numbers starting 110. are a Whirlpool-built front-load platform sold as HE2, HE2 Plus, HE5 and HE5 Steam. On them F27 reports an overflow: the control believes there is too much water in the tub. The drain pump runs constantly trying to empty it and the door stays locked. You will see F27 on the display, a pump running without stopping and a drum that may still hold water.

Common causes of F27

Water inlet valve that keeps letting water in
Water level sensing reading too high
Drain path that cannot keep up with the incoming water

✓ One safe check you can try

1. If water is on the floor, shut off both faucets behind the washer. 2. Unplug the washer to see whether water keeps filling the tub. 3. Do not force the door while it is locked. 4. Leave the faucets closed and the washer unplugged until it has been inspected.

! Why to stop there

Whether the inlet valve is passing water when it should be closed
Whether the level sensing is wrong while the tub is actually fine
Whether the drain path is partly blocked

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

PFKenmore 796 Front-Load Washer Code PF: Power failure during the cycle PFKenmore 796 Wi-Fi Front-Load Washer Code PF: Power loss message PFKenmore Calypso Top-Load Washer Code PF: Power failure rL / OU / F34Kenmore 110 HE Front-Load Washer Codes rL, OU and F34: Clothes in the Clean Washer cycle SdKenmore HE2 Front-Load Washer Code Sd: Too many suds SdKenmore HE5 Front-Load Washer Code Sd: Excessive suds SdKenmore HE5 Steam Front-Load Washer Code Sd: Suds not cleared Sd or F71Kenmore 110 Oasis Top-Load Washer Codes Sd and F71: Excessive suds

F27F27 questions

Why is my drain pump running nonstop with F27 on the display?

It is an overflow code. The control thinks the tub holds too much water, so on this Whirlpool-built HE platform it runs the drain pump and keeps the door locked until the level is safe.

Why does my pump run nonstop with F27?

The control is trying to remove what it believes is excess water. If water keeps coming in, the pump cannot win, which is why we check the inlet valve first.

Should I turn the faucets off?

Yes, if water is rising or there is any leak. Closing the faucets and unplugging the washer limits damage while you wait for a visit.

Book a visit

Still seeing F27?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 955-7152