Error code · Washer

Kenmore 110 HE Front-Load Washer Code F30: Dispenser actuator did not move

Medium · inspection needed

Code: F30
Appliance: Washer
Brand: Kenmore
Warranty: 30-day workmanship

What F30 means

On Kenmore washers whose model numbers start with 110., a Whirlpool-built HE2, HE2 Plus, HE5 and HE5 Steam front-load platform, F30 means the dispenser system failed. The dispenser actuator moves cams and levers that direct detergent, softener and bleach, and the control did not see it complete its movement. You will see F30 on the display, and the washer may stop before the wash begins or run without releasing the products.

Common causes of F30

Loose wiring between the dispenser actuator and the main electronic control board
Cam or levers in the dispenser that bind or do not travel
Dispenser actuator that does not respond when called

✓ One safe check you can try

1. Pull out the dispenser drawer and check for dried detergent, a stuck cap or anything jamming it. 2. Wipe the drawer slot and push it fully home. 3. Start a short cycle and watch whether F30 returns. 4. Leave the top panel closed. The actuator wiring is not an owner job.

! Why to stop there

Whether the actuator turns but the cam or levers are binding
Whether the wiring to the main electronic control board is sound
Whether the actuator or the board output is the weak part

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

SLKenmore Calypso Top-Load Washer Code SL: Excessive suds Spin LED onKenmore 110 VMW Top-Load Washer Spin Light On: Drain took too long Sud / SUDSKenmore Washer Codes Sud and SUDS: Excessive suds on 110, 796 and 402 front-loads tEKenmore 796 Washer Code tE: Thermistor and heating UEKenmore 796 Washer Code UE: Unbalanced load uLKenmore 110 Oasis Top-Load Washer Code uL: Unbalanced load Wash LED onKenmore 110 VMW Top-Load Washer Wash Light On: No fill or slow fill PFKenmore 796 Front-Load Washer Code PF: Power failure during the cycle

F30F30 questions

Is F30 a detergent drawer problem or an electrical one?

It is a dispenser system failure. The control told the dispenser actuator to move and did not get the expected result, so this Whirlpool-built HE platform stops and shows F30.

Can sticky detergent cause F30?

It can add drag to the drawer and the levers behind it, though F30 itself is about the actuator system. A clean drawer rules out the simple cause before we test the actuator.

Can I run a load without the dispenser?

Possibly, but we do not recommend dosing by hand into a washer that has stopped on F30. It is better to have the dispenser tested so the wash can run normally.

Book a visit

Still seeing F30?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 955-7152