Kenmore 110 VMAX Dryer Code F4 E4 (110 / Whirlpool-built VMAX): Low Line Voltage
Kenmore 110 VMAX dryers, built by Whirlpool, treat F4 E4 as low or no line voltage, the same condition as L2. It points to a problem in the home's power supply that keeps the heater from…
- Code
- F4 E4 (110 / Whirlpool-built VMAX)
- Appliance
- Dryer
- Brand
- Kenmore
- Warranty
- 30-day workmanship
What F4 E4 (110 / Whirlpool-built VMAX) means
Kenmore 110 VMAX dryers, built by Whirlpool, treat F4 E4 as low or no line voltage, the same condition as L2. It points to a problem in the home's power supply that keeps the heater from turning on. The owner sees the code and the drum may turn while the air stays cool. A dryer circuit has two poles, so one breaker leg dropping out is enough to cause it.
Common causes of F4 E4 (110 / Whirlpool-built VMAX)
- Two-pole breaker with one leg off
- Cord installed incorrectly
- Outlet or terminal connection
- Heater not receiving full voltage
1. Check both poles of the dryer breaker, and reset it if tripped. 2. Check that the power cord is installed correctly. 3. Run a Timed Dry heated cycle. 4. If the code stays, call an electrician or us. 5. Do not open the dryer's terminal area.
- It remains unclear whether the cause sits in the house supply or in the dryer's terminal and cord connection.
- We measure the supply at the outlet before testing the dryer.
- You see a written price first, and the work carries a 30-day warranty.
Other Dryer codes
Why would a dryer lose power on one leg?
A two-pole breaker can trip on only one side, or a connection can loosen over time. Either one leaves the heater without proper voltage while the drum still turns. Check the breaker panel first.
How does F4 E4 relate to L2?
Yes. On this 110-series, Whirlpool-built platform both describe the same low line voltage condition, and the same breaker and cord checks apply. Photograph the breaker position before you reset it.
Can I reset the breaker myself?
Yes. Switch it fully off and then on. Leave any wiring work at the outlet or terminal block to an electrician or to us. That one fix is often enough.
Still seeing F4 E4 (110 / Whirlpool-built VMAX)?
A technician diagnoses it on site and gives you the price in writing before any work starts.