29262
Kenmore 29262 Top-Load Impeller Washer Repair
Most common issues on this model
- Washer not spinning or spinning slowly
- Clothes tangled or twisted after a cycle
- Cycle stopping with the lid unlatched
- Suds or water left in the tub
The Kenmore 29262 is a 4.5 cu ft top-load washer in white with a Triple Action impeller wash system and multiple water-level and cycle settings. An impeller is a low disc at the bottom of the tub, in place of a center post.
A Kenmore washer reveals its builder only through the prefix on the data plate. We read that prefix to match parts and tests. Serial and full model are confirmed from the plate before any order.
With an impeller washer, tangled loads lead us to load size and water level first, then to the drive that turns the plate. We test the lid switch when the cycle stops early, and the drain pump when water is left behind. A spin that is slow or absent sends us to the motor, coupling and belt. Our price is in writing before we begin, and our labor is covered for 30 days.
Key features
- 4.5 cu ft capacity
- Top-load washer
- Triple Action impeller wash system
- Multiple water-level and cycle settings
- White
Error codes this model can show
Why are my clothes coming out twisted?
Overloading, low water or a worn drive that turns the plate poorly can all twist a load. We check the fill level, the drive and the balance, and tell you whether the issue is use or a part.
What does an impeller change when it comes to repairs?
The plate has no tall center post, but it still depends on a motor, coupling and transmission. We test them when the washer stops turning or cannot spin the tub at speed.
Why is there water left in the tub?
A clogged pump, a kinked hose or a pump that no longer turns can leave water behind. We clear the drain path, test the pump and run a short cycle to confirm it empties.
Book repair for your 29262
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.