Error code · Washer

Kenmore 417 Front-Load Washer Code E13: Tub Leak or Air Hose Leak

High · stop use, call now

Code: E13
Appliance: Washer
Brand: Kenmore
Warranty: 30-day workmanship

What E13 means

This applies to Kenmore front-load washers with model numbers starting 417, including 417.44130000 and the 2014+ digital-display versions. E13 reports water leaking in the tub, or an air leak in the hose that feeds the water level pressure sensor. The washer cannot measure its water level correctly, so it stops, and you may find water under the washer. The cycle ends without finishing the wash.

Common causes of E13

Cracked or leaking outer tub
Leaking hose or hose connection
Air leak in the water level pressure sensor hose

✓ One safe check you can try

1. Drain the washer if you can do so safely. 2. Unplug it and look under and around it for water. 3. Wipe up any pooled water and keep the area dry. 4. Do not run another cycle until a technician looks.

! Why to stop there

Whether the leak is in the tub, a hose or the pressure sensor air hose
If the outer tub itself is cracked the repair is larger and we will explain it plainly
After any flooding keep the washer unplugged until it is inspected

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

PFKenmore 796 Front-Load Washer Code PF: Power failure during the cycle PFKenmore 796 Wi-Fi Front-Load Washer Code PF: Power loss message PFKenmore Calypso Top-Load Washer Code PF: Power failure rL / OU / F34Kenmore 110 HE Front-Load Washer Codes rL, OU and F34: Clothes in the Clean Washer cycle SdKenmore HE2 Front-Load Washer Code Sd: Too many suds SdKenmore HE5 Front-Load Washer Code Sd: Excessive suds SdKenmore HE5 Steam Front-Load Washer Code Sd: Suds not cleared Sd or F71Kenmore 110 Oasis Top-Load Washer Codes Sd and F71: Excessive suds

E13E13 questions

What does the air hose have to do with it?

The pressure sensor reads water level through a small air hose. A leak in that hose gives wrong readings, and E13 is flagged even when the tub itself holds water.

Is the leak always water?

Not always. E13 covers both a water leak in the tub and an air leak in the sensor hose, and finding which one it is takes a proper look underneath and behind the cabinet.

Can I run it to see?

Please do not. Running water into a leaking tub can damage the floor and the washer, and after any flooding it should stay unplugged until it is inspected.

Book a visit

Still seeing E13?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 955-7152