Error code · Washer

Kenmore 110 VMAX Top-Load Washer Code F7 E1: Power dropped while spinning

Medium · inspection needed

Code: F7 E1
Appliance: Washer
Brand: Kenmore
Warranty: 30-day workmanship

What F7 E1 means

On Kenmore VMAX top-load washers whose model numbers start with 110., a Whirlpool-built platform, F7 E1 means power was lost while the washer was spinning. After power returns the washer pauses 5 minutes so the spin basket can come to a stop before the cycle continues. You will see F7 E1 and the cycle resumes late or ends. On the VMW version of this platform the same characters mean something else, a basket speed sensor problem, so check which one you own.

Common causes of F7 E1

Power cord not seated firmly at the outlet
Power cord damaged or wiring connection loose on the main electronic control board
Outlet supply dropping out under load

✓ One safe check you can try

1. Push the power cord plug fully into the outlet. 2. Look along the cord for cuts, crushed spots or heat marks. 3. Do not run the washer if the cord is damaged. 4. Do not open the cabinet to reach the cord connections.

! Why to stop there

Whether the outlet holds steady voltage during spin, which an electrician should check
Whether the cord connection on the board is loose
Whether the cord needs replacing

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

UEKenmore 796 Washer Code UE: Unbalanced load uLKenmore 110 Oasis Top-Load Washer Code uL: Unbalanced load Wash LED onKenmore 110 VMW Top-Load Washer Wash Light On: No fill or slow fill PFKenmore 796 Front-Load Washer Code PF: Power failure during the cycle PFKenmore 796 Wi-Fi Front-Load Washer Code PF: Power loss message PFKenmore Calypso Top-Load Washer Code PF: Power failure rL / OU / F34Kenmore 110 HE Front-Load Washer Codes rL, OU and F34: Clothes in the Clean Washer cycle SdKenmore HE2 Front-Load Washer Code Sd: Too many suds

F7 E1F7 E1 questions

Why does the washer wait before it finishes after F7 E1?

It means power was lost during the spin. The control pauses 5 minutes for the basket to stop, then continues, so on this Whirlpool-built platform it flags the interruption with F7 E1.

Is F7 E1 the same on every 110 washer?

No. On the VMW version the same characters point to a basket speed sensor. Check your washer type before assuming an outage, because the repair path differs completely.

Will the washer finish my load?

Usually it resumes after the pause once power is steady. If F7 E1 keeps returning, the cord, outlet or board connection should be tested, and we handle every part of that except the outlet wiring.

Book a visit

Still seeing F7 E1?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 955-7152