82282
Kenmore 82282 Steam Electric Dryer Repair
Most common issues on this model
- Steam option running without any steam in the drum
- Drum turning with no heat
- Door gasket worn or the door sitting crooked
- Loads needing a second run to dry
Kenmore lists the 82282 as an electric front-load dryer, 8.0 cu. ft., with AccelaSteam and several heat and cycle settings. The big drum is sized to go with front-load washers. It needs a 240-volt outlet and a clear exhaust vent.
Kenmore does not publish a builder for this model. The prefix on the label does, and we confirm it with the serial before any part is ordered. Heating, belt and steam parts all depend on the builder.
A steam cycle with no steam goes to the inlet, valve and spray first. No heat on an electric dryer sends us to the element, the fuse and the limit switch. If the door seal is worn or sits crooked, air escapes and drying drags, so we inspect it. We quote in writing before we start, and a 30-day workmanship warranty covers the repair.
Key features
- 8.0 cu. ft. electric front-load dryer
- AccelaSteam
- Drum sized for front-load washers
- Several heat and cycle settings
Error codes this model can show
Why is there no visible steam?
A closed water supply, a bad valve or a blocked spray can stop it. We check each and test the control.
Does a worn door seal matter?
Yes. It can leak air and lint and weaken drying. We inspect the seal and the door fit.
How does the 82282 differ from the 92272?
The 92272 is the gas version. The 82282 is electric, so heat comes from an element instead of a burner.
Book repair for your 82282
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.