Kenmore 417 Washer Code E67: Wrong voltage at the control chip
On Kenmore washers whose model numbers start with 417, E67 means the microprocessor on the electronic control board is getting the wrong supply voltage. The processor needs a steady low-voltage feed to run the program, and…
- Code
- E67
- Appliance
- Washer
- Brand
- Kenmore
- Warranty
- 30-day workmanship
What E67 means
On Kenmore washers whose model numbers start with 417, E67 means the microprocessor on the electronic control board is getting the wrong supply voltage. The processor needs a steady low-voltage feed to run the program, and when the board reports that feed is off, the washer halts the cycle. The owner sees E67 on the display and the washer stops responding normally. It is a control-power condition rather than a water or drain problem.
Common causes of E67
- Control board power supply that is out of range for the processor
- Electronic control board whose internal voltage regulation is unreliable
- Unstable household power reaching the washer
1. Unplug the washer for 5 minutes. 2. Restore power and see whether the code clears. 3. Make sure the washer is plugged straight into a wall outlet and not an extension cord. 4. If E67 comes back, leave the washer unplugged and call us.
- Whether the code comes from the board itself or from a poor supply at the outlet
- Whether the board still holds up under load after a reset
- The exact board version for your model so any replacement is correct
Other Washer codes
Why does my Kenmore 417 washer show E67?
The control board reports an incorrect voltage feeding its microprocessor. When that internal supply looks wrong, the washer stops the cycle instead of risking bad instructions.
Will unplugging the washer fix E67?
A five-minute unplug is worth trying because it fully powers down the board. If the code returns after you restore power, the board usually needs attention from us.
Does E67 mean my outlet is bad?
It can, but usually the problem is on the board. We check the outlet supply first so we do not replace a part that was never the cause.
Still seeing E67?
A technician diagnoses it on site and gives you the price in writing before any work starts.