Error code · Washer

Kenmore 110 HE Front-Load Washer Code F/14: Main board memory error

Medium · inspection needed

Code: F/14
Appliance: Washer
Brand: Kenmore
Warranty: 30-day workmanship

What F/14 means

On older Kenmore HE front-load washers whose model numbers start with 110, a Whirlpool-built platform with the F/xx display, F/14 is an EEPROM error on the main control board. The EEPROM is the memory chip that holds the board's settings and program data, and F/14 means that data has become corrupted. The washer stops and shows the code. It is a control board matter, not a water or drain one, and a power-down sometimes lets the board reload.

Common causes of F/14

Corrupted settings memory (EEPROM) on the main electronic control board
Power interruption or surge that damaged the stored data
Main control board that can no longer keep its memory

✓ One safe check you can try

1. Unplug the washer and leave it off for 5 minutes. 2. Plug it back in and check whether F/14 is gone. 3. If it has cleared, run a short test load. 4. If it comes back, stop and call us for a board check.

! Why to stop there

Whether the reset really cleared the memory or the code is only paused
Whether the board keeps corrupting its data
Which replacement board matches your model

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

uLKenmore 110 Oasis Top-Load Washer Code uL: Unbalanced load Wash LED onKenmore 110 VMW Top-Load Washer Wash Light On: No fill or slow fill PFKenmore 796 Front-Load Washer Code PF: Power failure during the cycle PFKenmore 796 Wi-Fi Front-Load Washer Code PF: Power loss message PFKenmore Calypso Top-Load Washer Code PF: Power failure rL / OU / F34Kenmore 110 HE Front-Load Washer Codes rL, OU and F34: Clothes in the Clean Washer cycle SdKenmore HE2 Front-Load Washer Code Sd: Too many suds SdKenmore HE5 Front-Load Washer Code Sd: Excessive suds

F/14F/14 questions

What is an EEPROM?

It is a small memory chip on the main board that stores the washer's settings and program data. If that data is damaged, the board reports F/14.

Will the five-minute unplug fix it?

It can. A full power-down lets the board restart and sometimes reload its memory. If F/14 returns, the board is no longer reliable and probably needs replacing.

Could a power surge have caused it?

Possibly. Surges can corrupt stored data, so a surge protector is wise after a repair. We quote in writing before replacing anything. A surge protector on the outlet is inexpensive protection for the board.

Book a visit

Still seeing F/14?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 955-7152