79162
Kenmore 79162 Gas Dryer Repair
Most common issues on this model
- Gas burner not igniting
- Sensor cycle ending early or running too long
- Several cycles needed to dry a normal load
- Gas smell or clicking without a flame
The Kenmore 79162 is a 7.0 cu. ft. gas dryer with a sensor drying system, several heat and cycle settings and a white finish. A gas dryer needs a gas line with a shutoff valve, a 120-volt outlet for the drum and controls, and a vent run to the outside.
The builder is not stated for this model. The model-number prefix on the label points to the manufacturer, and we confirm it and the serial before ordering ignition parts. Igniters, coils and valves are not interchangeable across builders.
When a gas dryer spins but does not heat, we check the igniter, the gas valve coils, the flame sensor and the high-limit parts, in a safe order and with the gas supply verified. A vent that is crushed or full of lint makes the burner cycle off early, so we measure that too. We turn the gas off and tell you if we smell any leak. We quote in writing first, and a 30-day workmanship warranty follows.
Key features
- 7.0 cu. ft. gas dryer
- Sensor drying system
- Multiple heat and cycle settings
- White finish
Error codes this model can show
My gas dryer clicks but never lights. What does that mean?
The igniter may be weak, or a gas valve coil may not open. We test the igniter current, the coils and the sensor, and we confirm gas reaches the dryer.
Can a gas dryer be used if I smell gas?
No. Turn off the gas supply, ventilate the room and leave. Call your gas utility, then call us once the line is cleared.
Why do loads take two cycles?
On dryers of this type, a short vent, a weak burner or a sensor that quits early are typical reasons. We test heat output and airflow first.
Book repair for your 79162
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.